CNC Billet 7075 billet aluminum
Replace the plastic factory barbell
The factory OE plastic barbell is approximately .020” to loose so particles as big as 500 Microns can leak passed the factory Barbell. When oil leaks pass the Barbell it goes unfiltered directly to the Cam Bearing, Lifters, Crank and Rod Bearings.
oil filter will filter out approximately 25 Microns depending on the brand of filter. Our Billet Barbell fits with approximately .001” clearance which will let only about 20-25 Microns pass by,this is the same as the filter.
Also another important part is the shaft of the Barbell. The oil has to flow around it to get through to the oil port. This Billet Barbell has a 30% smaller shaft for much less flow restriction.
Also this come 14-20 threaded hole in the end of our Barbell for easy removal. Just screw a 14-20 bolt in and pull the barbell out.
Better engine protection from much less and smaller particles bypassing, smaller less restrictive shaft for better oil flow, replaceable High Temperature Viton O-ring and for ease of service a threaded 14-20 hole.
Professional Installation is Highly Recommended (No Instruction Included)
1 x Aluminum Oil Diverter Barbell
As the picture shown
Fits LS1-2-3-6-7-9-LQ4-LQ9-4.8L-5.3L-6.0L-6.2L L92 LS4 L99 LSA & more!